K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
4. Install the boot in the caliper bore groove. The lip of the boot must firmly sit in the groove.
5. Install the piston inside J24548.
6. Install the piston halfway into the bore.
7. Remove J 24548. Make sure that the boot is sitting firmly in the groove.
NOTICE: Refer to Fastener Notice in Service Precautions.
8. Install the bleeder valve.
^
Tighten the bleeder valve to 13 Nm (110 inch lbs.).
Front
REMOVAL PROCEDURE
^
Tools Required
-
J 24548 Piston Ring Compressor
-
J 36474 75 mm Boot Seal Installer or
-
J 36475 80 mm Boot Seal Installer or
-
J 38453 86 mm Boot Seal Installer
