K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
1. Lubricate the caliper and the anchor plate sliding surfaces with Shell Aeroshell Grade 5 lubricant or equivalent.
NOTICE: Do not use NEVER SEIZE type products on the caliper V-ways and anchor plate guide way surfaces. These products are not
lubricants and result in high caliper slide forces which can cause increased wear of the brake pads.
2. Install the caliper assembly (1).
3. Install the spring (4) and the support key (3).
4. Drive the support key in place using a brass punch and a hammer.
NOTICE: Refer to Fastener Notice in Service Precautions.
5. Install the bolt (2). The boss on the bolt must fit into the circular cutout in the key.
^
Tighten the bolt to 20 Nm (15 ft. lbs.).
6. Install the brake hose.
