K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
Coolant Reservoir: Service and Repair
Surge Tank Replacement
REMOVAL PROCEDURE
1. Drain the coolant from the surge tank.
2. Disconnect the surge tank outlet hose (3) and clamp (2) from the surge tank as needed. The hose, mounting, and clips may vary from engine to
engine.
3. Disconnect the surge tank overflow hose (4) and clamp (2) as necessary. The overflow hose attachment may vary from engine to engine.
4. Disconnect the surge tank inlet hose as necessary. The hose, mounting, and clips may vary from engine to engine.
5. Remove the surge tank bolts.
6. Remove the surge tank (1) from the vehicle.
INSTALLATION PROCEDURE
1. Install the surge tank (1) into the vehicle.
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Install the bolts.
^
Tighten the bolts to 10 Nm (89 inch lbs.).
3. Connect the surge tank inlet hose as needed. The hose, mounting, and clips may vary from engine to engine.
4. Connect the coolant overflow hose (4) and clamp (2) to the surge tank as needed. The overflow hose attachment may vary from engine to engine.
5. Connect the surge tank outlet hose (3) and the clamp (2) to the surge tank. The hose, mounting, and clips may vary from engine to engine.
6. Refill the coolant to the surge tank.
