K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
Engine Mount: Service and Repair
Engine Mount Replacement (Left Side)
REMOVAL PROCEDURE
IMPORTANT: When performing this service procedure, do not lift the engine block by the crankshaft balancer. Damage to the crankshaft balancer,
crankshaft pulleys, or the crankshaft could occur.
Do not replace the left or right at the same time. They must be replaced in two separate service procedures, so as not to cause an alignment problem
when re-installing the engine mounts.
1. Disconnect both the battery negative cables from the batteries. Refer to Battery Cable in Powertrain Management.
2. Raise the vehicle and support with safety stands.
3. Move the front wheel to the left against the steering stops.
4. Install the pole jack on the engine locating tab just to the left rear of the power steering pump.
5. If servicing a 2 wheel drive vehicle, remove the engine mount assembly bolts, nuts, and washers.
