K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
Fuse Block: Service and Repair
Fuse Block Replacement (Fuse Block)
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Remove the fuse block cover. The cover is on the left end of the instrument panel.
3. Remove the fuse block.
3.1. Remove the screw at the bottom of the fuse block.
3.2. Push the fuse block in at the bottom. The fuse block will pivot clear of two mounting tabs at the top of the fuse block.
3.3. Push the fuse block back and away from the instrument panel.
3.4. Mark the fuse block and the wire locations for reassembly.
4. Remove the wires from the fuse block.
5. Remove the fuse block from the vehicle.
6. Remove the fuses from the block.
INSTALLATION PROCEDURE
1. Install the fuses into the block.
2. Install the fuse block into the vehicle.
3. Install the wires to the fuse block in the original locations.
4. Install the fuse block into the instrument panel.
4.1. Place the two tabs at the at the top of the fuse block onto the tabs of the instrument panel.
4.2. Push the bottom of the fuse block into place from behind the block. Align the screw hole and attach the retaining screw.
5. Install the fuse block cover to the instrument panel.
6. Connect the negative battery cable.
