K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
Intake Air Temperature (IAT) Sensor: Service and Repair
REMOVAL PROCEDURE
CAUTION: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be
OFF unless instructed otherwise in these procedures If a tool or equipment could easily come in contact with a live exposed electrical terminal,
also disconnect the negative battery cable Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its
components.
1. Remove the negative battery cables.
2. Remove the electrical connector.
3. Remove the IAT sensor.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Cautions and Notices.
