K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
32. Stretch the passenger harness to full length.
33. Completely cover the windshield and front door window openings with a drop cloth.
34. Place a power source, 12 volt minimum/2A minimum (i.e., a vehicle battery) near the shorted end of the harness.
35. Separate the two ends of the driver deployment harness wires.
36. Connect the driver deployment harness wires to the power source in order to deploy the Inflatable Restraint Steering Wheel Module.
37. Disconnect the driver deployment harness wires from the power source.
38. Separate the two ends of the passenger deployment harness wires.
39. Connect the passenger deployment harness wires to the power source in order to deploy the Inflatable Restraint IP module.
40. Disconnect the passenger deployment harness wires from the power source.
41. Twist together one end of each wire on the driver deployment harness in order to short the wires.
42. Twist together one end of each wire on the passenger deployment harness in order to short the wires.
43. Remove the drop cloth from the vehicle.
44. Disconnect both harnesses from the vehicle.
45. Discard the harnesses.
46. Scrap the vehicle in the same manner as a non-SIR equipped vehicle.
47. If one or both of the modules did not deploy, perform the following steps:
47.1.Remove the undeployed module(s) from the vehicle.
47.2.Temporarily store the module(s).
47.3.Call the Technical Assistance Group for further assistance.
