K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
1. Install the starter to the engine.
NOTE: Refer to Fastener Notice in Cautions and Notices.
2. Install the bracket nut and washer to the bracket over the end of the starter.
Tighten
Tighten the bracket nut to 8 N.m (6 lb ft).
3. Install the starter mounting bolts and washers, if equipped, through the starter to the engine.
Tighten
Tighten the starter mounting through bolts to 45 N.m (35 lb ft).
4. Connect the battery positive cable and the wiring harness to the starter.
Tighten
Tighten the nut to 11 N.m (100 lb in).
5. Remove the stands and lower the vehicle.
6. Connect the battery negative cable.
