K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
Power Steering Line/Hose: Service and Repair
Power Steering Gear Inlet Hose Replacement
With Hydroboost
REMOVAL PROCEDURE
1. Install a drain pan under the vehicle.
2. Siphon the power steering fluid from the reservoir to prevent excessive spillage.
3. Remove the power steering gear inlet hose (3) from the hydraulic brake booster.
Notice: Do not start the vehicle with any power steering gear inlet or outlet hoses disconnected. When disconnected, plug or cap all openings of
components. Failure to do so could result in contamination or loss of power steering fluid and damage to the system.
4. Remove the power steering gear inlet hose (3) from the power steering gear.
5. Remove the power steering gear inlet hose from the vehicle.
Notice: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation
easier. Failure to follow these procedures could result in component damage.
INSTALLATION PROCEDURE
1. Route the hose in the same position the hose occupied prior to removal.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the power steering gear inlet hose (3) to the hydraulic brake booster.
-
Tighten the power steering gear inlet hose (3) at the hydraulic brake booster to 27 Nm (20 ft. lbs.).
3. Install the power steering gear inlet hose (3) to the power steering gear.
