K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
Power Steering Pump: Service and Repair
Power Steering Pump Replacement
REMOVAL PROCEDURE
-
Tools Required
-
J25034-C Power Steering Pump Pulley Remover
1. Place a drain pan below the pump.
2. Remove the hoses.
3. Cap the hoses.
4. Remove the drive belt.
5. Remove the pulley.
5.1. Install the J25034-C.
5.2. Be sure the pilot bolt bottoms in the pump shaft by turning the nut to the top of the pilot bolt.
5.3. Hold the pilot bolt.
5.4. Turn the nut counterclockwise.
6. Remove the front mounting bolts.
7. Remove the rear mounting nuts from the studs.
8. Remove the electrical connector from EVO actuator.
9. Remove the pump.
INSTALLATION PROCEDURE
-
Tools Required
-
J25033-C Power Steering Pump Pulley Installer