K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
^
Tighten the link assembly nuts to 125 Nm (92 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the adjustment retainer plate and the bolt on both torsion bars.
7. Using the J 36202, increase the tension on the torsion bar.
8. Install the retaining plate and the adjustment bolt.
9. Set the adjustment bolt to 34 mm (1.3 inch).
10. Release the tension on the torsion bar until the load is taken up by the adjustment bolt.
11. Remove the J 36202.
12. Lower the vehicle.
13. Check the Z height.
