K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
Differential Axle Housing: Service and Repair
Front Drive Axle
Removal Procedure
1. Remove the front differential carrier shield (if equipped).
2. Remove the clamp (3).
Important: Make note of the routing in order to aid in reassembly.
3. Remove the vent hose (4) from the axle.
4. Remove the bolt (1).
5. Remove the clip (6).
6. Remove the vent hose (7).
Installation Procedure
1. Install the vent hose (4) to the vehicle.
^
Route the same way as when removed.
^
Make sure the hose is free of kinks and is routed clear of sharp components.
^
Make sure the vent is not plugged.
2. Install the clip (6).
3. Install the bolt (1) and the clamp (2).
4. Install the vent hose (4) to the axle fitting.
5. Install the clamp (3).
6. Install the front differential carrier shield (if equipped).
