K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
9. Hold the pinion flange with the J 8614-O1.
10. Remove the pinion flange nut and washer.
11. Use a container to catch any lubricant.
12. Remove the pinion flange using the J8614-O1 with the remover attachment.
Important: Avoid damaging the machined surfaces.
13. Pry the oil seal from the bore.
14. Thoroughly clean any foreign material from the contact area.
15. Replace any parts as necessary.
Installation Procedure
1. Install the oil seal into the bore using the J 22804-1 and either the J 22388 (9 1/2 inch ring gear axles) or the J 22836 (8 1/2 and 8 5/8 inch ring
gear axles).
2. Turn the J 22804-1 from the installed position 180° to ensure proper installation against the pinion flange.
3. Lubricate the cavity between the new seal lips with a high melting point lubricant for bearings.
