K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
6. If the bearing cup is not completely removed, do the following:
6.1.
Lift the cross and insert the J 9522-5 between the seal and the bearing cup.
6.2.
Continue pressing the bearing cup out of the yoke.
7. Rotate the propeller shaft and press the opposite bearing cup out of the yoke.
8. Remove the cross from the yoke.
9. Remove the remaining universal joint parts from the yoke.
10. If you are replacing the front universal joint, remove the bearing cups in the slip yoke in the same manner.
11. Inspect the retaining ring grooves for dirt, corrosion, or pieces of the old ring.
12. Inspect the bearing cup bores for burrs or imperfections.
Important: Corrosion or dirt may prevent the bearing cup installation and may prohibit the proper seating of the bearing retainers.
13. Clean the retaining ring grooves.
Installation Procedure