K 1500 Truck 4WD V6-262 4.3L VIN Z (1993)
Vacuum Brake Booster: Description and Operation
The power brake booster is a tandem diaphragm vacuum-suspended unit. When the engine is running, inlet manifold vacuum is transmitted to the
booster unit through a vacuum hose. A check valve at the power brake booster end of the hose keeps air from flowing from the hose into the booster unit
and weakening the power brake operating force when inlet manifold vacuum is low.
With the service brakes released, vacuum is supplied equally to both sides of the two diaphragms in the booster unit. Because pressure on both sides of
the diaphragms are balanced, no boost is provided to the braking system and the brakes are not applied.
When the driver presses down on the brake pedal, the pedal pushrod depresses a spring-loaded air valve within the power brake booster. The air valve
opens to admit air at atmospheric pressure to the back side of both diaphragms. This forces the diaphragms forward and causes a piston rod in the
booster unit to push the brake master cylinder pistons and apply the service brakes.
The amount of atmospheric air admitted to the back side of both diaphragms depends upon the force the driver applies to the brake pedal. The greater
the pedal pressure, the more the valve opens. This provides a power boost that multiplies the force applied to the master cylinder pistons in proportion to
the pressure on the brake pedal.
When the brake pedal is released, the flow of atmospheric air is cut off and inlet manifold vacuum draws off the air behind the diaphgrams. As a
result, air pressures within the diaphgram chambers are once again balanced so no power boost is developed.
