K 1500 Truck 4WD V6-262 4.3L VIN Z (1993)
^
Mark the pitman arm and the pitman shaft. This will permit proper alignment at assembly.
3. Pitman arm using J 6632-01 or J 29107.
INSPECT
^
Ball stud threads for damage.
^
Ball stud seals for excessive wear.
CLEAN
^
Threads on the ball stud.
Steering Linkage (K-Models)
INSTALL OR CONNECT
TOOLS REQUIRED:
^
J 29194 Steering Linkage Installer (14 mm).
NOTICE: If a clamp type pitman arm is used, spread the pitman arm just enough, with a wedge, to slip the arm onto the pitman shaft. Do. not
spread the pitman arm more than required to slip over the pitman shaft with hand pressure. Do not hammer, or damage to the steering gear
