K 1500 Truck 4WD V6-4.3L VIN W (1997)
Brake Hose/Line: Service and Repair
WARNING: Always Use double-flared steel brake pipe when replacing brake pipes. The use of any other pipe is not recommended and may cause
brake system failure. Carefully route and retain replacement brake pipes. Always use the correct fasteners and the original location for replacement brake
pipes. Failure to properly route and retain brake pipes may cause damage to the brake pipes and lead to brake system failure. Brake pipes that run
parallel to each other must maintain a 6 mm (1/4 inch) clearance.
NOTE: Clean dirt, grease and other foreign material from the hose fittings at both ends.
Flexible Hose
Remove or Disconnect
1. Steel pipe.
2. Clip or nut.
3. Bolt.
4. Washers.
5. Hose.
Install or Connect
1. Hose.
^
Use new copper washers when installing the hose.
^
The hose must not be twisted or contact any suspension components.
2. Washers.
3. Bolt.
4. Clip or nut.
5. Steel pipe.
6. Bleed brakes. Refer to Hydraulic System Service and Repair. See: Brake Bleeding/Service and Repair/System Bleeding
