K 1500 Truck 4WD V6-4.3L VIN W (1997)
Fuel Tank Pressure Sensor: Description and Operation
DESCRIPTION
The Fuel Pressure sensor is a three wire strain gauge sensor much like that of the common Manifold Absolute Pressure (MAP) sensor However, this
sensor has very different electrical characteristics due to its pressure differential design. The sensor measures the difference between the air pressure (or
vacuum) in the fuel tank and the outside air pressure.
PURPOSE
The sensor mounts at the top of the fuel tank sending unit. A three wire electrical harness connects it to the PCM. The PCM supplies a 5 volt reference
voltage and a ground to the sensor. The sensor will return a voltage between 0.1 and 4.9 volts.
When the air pressure in the fuel tank is equal to the outside air pressure, such as when the fuel fill cap is removed, the output voltage of the sensor will
measures 1.3 to 1.7 volts.
When the air pressure in the tank is 4.5 inches H2O (1.25 kPa), the sensor output voltage should measure 0.5 plus/minus 0.2 volts. When there is neither
a vacuum or a pressure in the tank, the sensor voltage should be at 1.5 volts at 14 inches H2O (-3.75 kPa) the sensor output voltage should be 4.5 volts
plus/minus 0.2 volts.
Refer to EVAP Control System Diagnosis for diagnosis of the fuel tank pressure sensor. Refer to System Diagnosis / Diagnostic Tables for testing
information. See: Testing and Inspection
