K 1500 Truck 4WD V8-305 5.0L VIN M SFI (1996)
-
Extend the propeller shaft to its full length, then compress it about half its stroke.
1. Propeller shaft to front axle.
-
Line up the reference marks made previously.
2. Retainers and bolts.
-
Tighten retainer bolts to 20 Nm (15 ft. lbs.).
3. Propeller shaft to transfer case.
-
Line up the reference marks made previously.
-
Adjust the propeller shaft length.
-
Support the propeller shaft.
4. Retainers and the bolts.
-
Tighten retainer bolts to 20 Nm (15 ft. lbs.).
5. Front differential carrier shield, (if equipped).
Slip Yoke Splines
Apply chassis lubricant at the slip spline grease fitting until the grease begins to leave through the vent hole.
If the slip spline is dry or corroded, it may be necessary to disconnect the propeller shaft from the vehicle, remove the slip yoke, and wire brush the
affected area. Wipe clean before installation.
