K 1500 Truck 4WD V8-4.8L VIN V (2003)
Keyless Entry Transmitter Battery: Service and Repair
TRANSMITTER BATTERY REPLACEMENT
REMOVAL PROCEDURE
Under normal use, the battery in the transmitter will last about 2 years. For battery replacement, use a Panasonic(r) 3 volt, type CR2032, or equivalent.
1. Open the transmitter case and perform the following steps:
1.1.
Insert a dime between the 2 halves of the transmitter near the key ring hole.
1.2.
Twist the dime.
2. Remove the battery.
INSTALLATION PROCEDURE
1. Install the battery with the (+) positive side down.
2. Close the transmitter case and perform the following steps:
2.1.
Align the top and bottom covers.
2.2.
Press together the top and the bottom covers.
2.3.
Inspect the operation of the transmitter.
3. Synchronize the transmitter.