K 1500 Truck 4WD V8-4.8L VIN V (2003)
Power Seat Control Module: Customer Interest
Interior - Seat Heater/Power Memory Seat Inoperative
File In Section: 08 Body and Accessories
Bulletin No.: 03-08-50-003
Date: January, 2003
TECHNICAL
Subject:
Seat Heater and/or Memory Power Seat Inoperative
(Replace Memory Seat Control Module)
Models:
2003 Cadillac Escalade, Escalade ESV, Escalade EXT
2003 Chevrolet Avalanche, Silverado, Suburban, Tahoe
2003 GMC Sierra, Yukon, Yukon XL, Yukon Denali, Yukon Denali XL
2003 HUMMER H2
Condition
Some customers may comment that the seat heater and/or memory seat functions are inoperative.
Cause
A logic lockup of the memory seat control module may cause this condition.
Correction
Important:
This repair is not to be performed on vehicles without memory/heated seats. If the vehicle does not have memory/heated seats but has an inoperative
power seat, use published Service Information to diagnose the concern.
If the seat is currently inoperable, perform the following diagnostic steps to determine if replacement of the memory seat control module is the correct
repair:
1.
Connect a Tech 2(R) to the vehicle and monitor the parameters in the sensor data list for the driver seat module as you try to move the seat. Are
the displayed data parameters changing, or does the Tech 2(R) display no communication as the seat switch is moved to various positions? If the
data parameters do not change, the memory seat control module may be inoperative due to a logic lockup.
2.
Remove the SEAT circuit breaker in the instrument panel relay block located under the left side of the instrument panel next to the parking brake.
This circuit breaker also supplies power to the passenger seat.
3.
Verify that the circuit breaker is not open. If it is not open, wait 30 seconds and then reinstall the circuit breaker.
4.
Try to move the seat again.
5.
If the seat moves or the data parameters displayed on the Tech 2(R) change when the seat switch is activated, replace the memory seat control
module. Use the Memory Seat Control Module Replacement procedure in SI.
6.
If the memory seat is still inoperative, use normal Service Manual diagnostics to determine the cause of this condition.
