K 1500 Truck 4WD V8-4.8L VIN V (2003)
Note: Refer to Fastener Notice in Cautions and Notices.
5. Bolt the cable to the differential (clips).
-
Tighten the bolt to 25 N.m (18 lb ft).
Important: After installing the cable to the rear axle holding clip, verify that clip is securely retaining the cable. If not, crimp the clip by hand taking
care not to pinch or kink the cable.
6. Install the cable to the differential clip.
7. For 25/35 series vehicles, connect the cable at the equalizer.
8. For 25/35 series vehicles, enable the park brake cable automatic adjuster. Refer to Enabling the Park Brake Cable Automatic Adjuster.
9. For all 15 series vehicles, pull down on the park brake cable in front of the equalizer and install the left park brake cable to the equalizer bar.
10. Remove the safety stands.
11. Remove the safety stands and lower the vehicle.
12. Adjust the park brake cable. Refer to Park Brake Adjustment.
Park Brake Cable Guide Replacement
Park Brake Cable Guide Replacement
Removal Procedure
1. Release the parking brake.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
