K 1500 Truck 4WD V8-4.8L VIN V (2003)
14. If vehicle is a extended cab, remove the fuel feed, EVAP, and return pipe assembly nuts.
15. Remove the fuel feed, EVAP, and return pipe assembly.
INSTALLATION PROCEDURE
1. Install the fuel feed, EVAP, and return pipe assembly.
NOTE: Refer to Fastener Notice in Service Precautions See: Service Precautions/Vehicle Damage Warnings/Fastener Notice.
2. If vehicle is a extended cab, install the fuel feed, EVAP, and return pipe assembly nuts.
Tighten
Tighten the nuts to .........................................12 N.m (106 lb in).
3. If vehicle is a regular cab, install the fuel feed, EVAP, and return pipe assembly nuts.
Tighten
Tighten the nuts to ...........................................12 N.m (106 lb in).
4. Remove the caps from the fuel pipes at the fuel tank.
