K 1500 Truck 4WD V8-4.8L VIN V (2003)
1. Install the locating pins to the NEW encoder motor.
2. Position a NEW actuator insulator gasket to the transfer case.
3. Install the encoder motor.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install encoder motor bolts.
Tighten the bolts, in the sequence shown to 20 Nm (115 ft. lbs.).
5. Connect the encoder motor electrical connector (7).
6. Connect the transfer case switch electrical connector (2).
7. Install the front propeller shaft.
8. Install the transfer case shield.
Transfer Case Speed Sensor Replacement - Front
Transfer Case Speed Sensor Replacement - Front
Removal Procedure
1. Remove the transfer case shield, if equipped.
