K 1500 Truck 4WD V8-4.8L VIN V (2003)
1. Install the control module to the vehicle.
2. Install the control module (2) retaining bolts (1).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the bolts to 24 N.m (18 lb ft).
3. Connect the electrical connectors to the module.
4. Program the control module. Refer to Service Programming System (SPS) (Remote Procedure)Service Programming System (SPS) (Pass-Thru
Procedure) Service Programming System (SPS) (Off Board Remote Procedure) Service Programming System (SPS) (Off Board Pass-Thru
Procedure) in Programming.
5. Install the spare tire to the vehicle.
6. Lower the vehicle.
7. Perform a learn alignment. Refer to Measuring Wheel Alignment (With Rear Wheel Steering) Measuring Wheel Alignment (Without Rear Wheel
Steering) in Wheel Alignment. See: Testing and Inspection/Programming and Relearning
