K 1500 Truck 4WD V8-4.8L VIN V (2003)
1. Install the filter neck seal.
2. Install the oil filter.
3. Install the oil pan gasket to the pan.
4. Install the magnet into the bottom of the pan.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the oil pan bolts.
^
Tighten the bolts to 11 Nm (97 inch lbs.).
6. Apply a small amount of sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent to the treads of the drain plug, if equipped.
7. Install the oil pan drain plug, if equipped.
^
Tighten the plug to 18 Nm (13 ft. lbs.).
8. Lower the vehicle.
9. Fill the transmission to the proper level with Dexron-III transmission fluid.
