K 1500 Truck 4WD V8-4.8L VIN V (2003)
^
The CV joint assembly (1)
^
The swage ring (2)
26. Install the top half of J36652 onto the lower half of the tool, over the CV joint seal (3) and the CV joint assembly (1).
27. Align the swage ring (2) and the swage ring clamp.
28. Insert the bolts into J 36652. Hand tighten the bolts until the bolts are snug.
Tighten each bolt 180 degrees at a time. Alternate between the bolts until both sides of the top half of J 36652 touch the bottom half of the tool.
29. Loosen the bolts and remove the halfshaft assembly from J36652.
