K 1500 Truck 4WD V8-5.7L VIN R (1997)
Diesel Engine Starter Motor
Remove or Disconnect
1. Negative battery cable. Refer to CAUTION. See: Service Precautions
2. Starter brackets and/or shields, if equipped.
3. Wires from the starter solenoid.
-
Raise the vehicle and support with safety stands.
4. Two bolts and washers (where present) holding the starter to the engine.
5. Starter from the engine.
INSTALL OR CONNECT
NOTICE: Refer to "Notice". See: Service Precautions/Vehicle Damage Warnings
1. Two bolts and washers (where used) through the starter to the engine.
Tighten
-
Mounting bolts (diesel) to 40 N.m (30 lb ft).
-
Mounting bolts (gas) to 45 N.m (33 lb ft).
-
Bracket Nut (diesel) to 8 N.m (75 lb in).
-
Nut (diesel) to 8 N.m (75 lb in).^ Lower the vehicle.
2. Wires to the solenoid terminals.
3. Brackets and/or shields, if equipped.
Tighten
-
Heat Shield bolts (diesel) to 17 N.m (13 lb ft).
-
Heat Shield bolts (gas) to 12 N.m (9 lb ft).
4. Negative battery cable.