K 1500 Truck 4WD V8-6.5L DSL Turbo VIN F (1999)
8. Install the fuel injection pump drive gear to the fuel injection pump.
^
Tighten the bolts to 25 Nm (20 ft. lbs.).
9. Install the crankshaft balancer to the crankshaft. Refer to Crankshaft Balancer Replacement.
10. Install the water pump to the engine block. Refer to Water Pump Replacement (Diesel) in Cooling System.
IMPORTANT: Check the marks on the fuel line clips made during removal. Ensure that the fuel line clips are re-installed on the proper studs.
11. Install the fuel return line clips.
12. Install the crankshaft position sensor to the engine front cover. Refer to Crankshaft Position Sensor (CKP) Replacement in Powertrain
Managements.
13. Install the right accessory bracket to the engine block. Refer to Accessory Brackets Replacement (Right Side).
14. Install the left accessory bracket to the engine block. Refer to Accessory Brackets Replacement (Left Side).
15. Install the A/C compressor to the left accessory bracket.
16. Install the lower fan shrouds to the radiator. Refer to Fan Shroud Replacement (Lower) in Cooling System.
17. Lower the vehicle.
18. Install the drive belt on the drive pulleys. Refer to Drive Belt Replacement.
19. Install the upper fan shroud to the radiator. Refer to Fan Shroud Replacement (Upper) in Cooling System.
20. Connect both the battery negative cables to the batteries. Refer to Battery Cable in Powertrain Management.
21. Reset the TDC off set timing procedure. Refer to TDC Offset Adjustment.
