K 1500 Truck 4WD V8-6.5L DSL Turbo VIN F (1999)
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Remove the right rear quarter trim panel.
3. Disconnect the electrical connectors, as necessary.
4. Remove the screws securing the blower motor resistor (1).
5. Remove the blower motor resistor.
INSTALLATION PROCEDURE
1. Install the blower motor resistor (1).
NOTE: Refer to Fastener Notice in Cautions and Notices.
2. Install the screws in order to secure the blower motor resistor.
Tighten
Tighten the screws to 1.4 N.m (12 lb in).
3. Connect the electrical connectors, as necessary.
4. Install the right rear quarter trim panel.
5. Connect the negative battery cable.
6. Test the circuit operation.
Blower Motor Resistor Replacement - Auxiliary (Suburban)
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
