K 2500 Suburban 4WD V8-6.0L VIN U (2001)
7. Locate and drill the center of the hinge welds using a 13 mm (1/2 in) drill bit or the equivalent.
8. If necessary, use a chisel in order to separate the hinge from the pillar.
9. Remove the hinge.
Installation Procedure
1. Clean and prepare the pillar surface in order to ensure a flush fit of the service hinge and the fasteners.
Important: Prior to refinishing, refer to GM 4901MD-99 Refinish Manual for recommended products. Do not combine paint systems.
Refer to paint manufacturer's recommendations.
2. Apply an approved anti-corrosion primer.