K 2500 Suburban 4WD V8-6.0L VIN U (2001)
14.
Roll up the seat back cover as far as necessary in order to access the bolts attaching the recliner/latch assembly to the seat back frame.
15.
Remove the recliner/latch assembly attaching bolts from the seat back frame and remove the recliner/latch assembly.
16.
Install the new recliner/latch assembly to the seat back frame and install the attaching bolts.
Tighten
Tighten the bolts to 45 N.m (33 lb ft).
17.
Roll the seat back cover material down.
18.
Position the seat back lower folding panel to the seat back and install three rivets, P/N 2477054, or equivalent.
19.
Reconnect the J-strip on the seat back cover at the bottom of the seat back.
20.
Install the seat belt buckle to the recliner/latch assembly and install the nut.
Tighten
Tighten the nut to 9 N.m (80 lb in).
21.
Install the seat back to the seat track base in the vehicle and install the bolts.
Tighten
Tighten the bolts to 35 N.m (26 lb ft).
22.
Connect the easy entry seat back cable.
23.
Install the right hinge cover on the 60% seat assembly.
24.
Install the inboard hinge cover.
25.
Install the outboard seat track cover and install the fasteners.
26.
Install the seat back release handle and install the attaching screw.
Tighten
Tighten the screw to 2 N.m (18 lb in).
27.
Position the seat belt buckles and fold the seat back and cushion to the upright position.
Parts Information
Pans are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use the table.
