K 2500 Suburban 4WD V8-6.0L VIN U (2001)
1. Install the anti-rattle clips to the bracket.
2. Install the brake pads to the bracket.
3. Install the brake caliper to the bracket.
4. Perform the following procedure before installing the caliper bracket mounting bolts and the caliper mounting bolts:
^
Remove all traces of the original adhesive patch.
^
Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
^
Apply Threadlocker GM P/N 12345493 or Red LOCTITE #272 to the threads of the bolt.
5. Install the brake caliper mounting bolts. Do not tighten.
6. Install the bracket and brake caliper as an assembly.
Notice: Refer to Fastener Notice in Service Precautions.
7. Install the caliper bracket mounting bolts.
^
Tighten the caliper bracket mounting bolts to 300 Nm (221 ft. lbs.).
8. Tighten the brake caliper mounting bolts.
^
Tighten the brake caliper mounting bolts to 108 Nm (80 ft. lbs.).
9. Install the tire and wheel assembly.
10. Remove the safety stands.
11. Lower the vehicle.
12. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
13. Slowly release the brake pedal.
14. Wait 15 seconds, then repeat steps 12-13 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
15. Fill the master cylinder reservoir to the proper level with clean brake fluid.
