K 2500 Suburban 4WD V8-6.0L VIN U (2001)
Thermostat Bypass Hose: Service and Repair
Coolant Air Bleed Hose Replacement
Removal Procedure
1. If necessary, remove the engine sight shield.
2. Remove the generator.
3. Reposition the coolant air bleed hose clamp at the throttle body.
4. Remove the coolant air bleed hose from the throttle body.
5. If equipped with the 4 point pipe, reposition the hose clamp at the pipe.
6. Remove the coolant air bleed hose (2) from the pipe (1).
7. If equipped with the 2 point pipe, reposition the hose clamp at the pipe.
8. Remove the coolant air bleed hose (2) from the pipe (1).
Installation Procedure