chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Exhaust System - Rattle/Popping Noise from Under Vehicle|Page 4512 > < Exhaust System - Rattle/Popping Noise from Under Vehicle|Page 4506
Page 1
background image

Heat Shield: All Technical Service Bulletins
Exhaust System - Rattle/Popping Noise from Under Vehicle

File In Section: 06 - Engine/Propulsion System

Bulletin No.: 02-06-05-005B

Date: April, 2003

TECHNICAL

Subject:
Exhaust/Muffler Heat Shield Rattle, Popping Noise Under Vehicle 
(Install Heat Shield Retaining Straps On Muffler)

Models:
2002-2003 Cadillac Escalade, Escalade EXT
2000-2003 Chevrolet Silverado, Suburban
2002-2003 Chevrolet Avalanche
2000-2003 GMC Denali, Denali XL, Sierra, Yukon XL
2003 HUMMER H2
with 5.3L or 6.0L Gas Engine (VINS T, N, U - RPOS LM7, LQ9, L04)
Except 1500 Series Models

This bulletin is being revised to add RPO L04 to the Models information. Please discard Corporate Bulletin 02-06-05-005A (Section 06 -
Engine/Propulsion System).

Condition

Some customers may comment on a rattle/popping noise from under the vehicle.

Cause

The separation of the muffler heat shield from the muffler may cause a rattle under the vehicle.

Correction

Install two heat shield retaining straps, P/N 15164621, to the muffler and muffler heat shield. Follow the service procedure below to correct this concern.

1.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (SI Document ID # 737171).

2.

Install a retaining strap, P/N 15164621, around the front of the muffler and muffler heat shield as shown above.

3.

Pull the retaining strap tight with one hand and tighten the Allen head screw with the other hand.

Tighten

Exhaust System - Rattle/Popping Noise from Under Vehicle|Page 4512 > < Exhaust System - Rattle/Popping Noise from Under Vehicle|Page 4506