K 2500 Suburban 4WD V8-6.0L VIN U (2001)
18. Pinch the new swage ring (2) slightly by hand to distort it into an oval shape.
19. Slide the distorted swage ring (2) over the large diameter of the seal (1).
Important: Be sure that the retaining ring side of the CV joint inner race faces the halfshaft bar (3) before installation. Slide the CV joint (4) onto the
halfshaft bar (3). The retaining snap ring inside of the inner race engages in the halfshaft bar groove with a click when the CV joint (4) is in the proper
position.
20. Pull on the CV joint (4) to verify engagement.
21. Slide the large diameter of the CV joint seal (1), with the large swage ring (2) in place, over the outside edge of the CV joint outer race (4).
22. Clamp the CV joint seal (2) tightly to the CV joint outer race (1) with the large swage ring, using the following procedure:
22.1.
Mount J 36652 in a vise.
22.2.
Install the bottom half of the split-plate swage clamp. For K1 5 models, use J 36652-1.
22.3.
For K25 models, use J 36652-1.
22.4.
Position the CV joint end (outboard end) of the halfshaft assembly in the bottom half of J 36652-1.
23. Align the following during this procedure:
^
The CV joint seal (3)
^
The CV joint assembly (1)
^
The swage ring (2)
