K 2500 Suburban 4WD V8-6.0L VIN U (2001)
^
Tools Required
-
J 42738 Seal Installer
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case assembly.
3. Remove the transfer case input shaft seal.
Installation Procedure
Important: When installing the input shaft seal, make sure that the part numbers on the seal are facing outward (toward the technician).
1. Align the transfer case input shaft seal evenly on the input shaft.
Important: The input shaft seal should be even with the surface of the transfer case after installation.
2. Using the J 42738, install the transfer case input shaft seal.
3. Install the transfer case assembly.
4. Check the transfer case fluid level.
5. Lower the vehicle. Refer to Vehicle Lifting.
Transfer Case - NVG 263-NP1 (Selectable)
Transfer Case Input Shaft Seal Replacement
^
Tools Required
-
J 42738 Seal Installer
Removal Procedure
