K 2500 Suburban 4WD V8-6.0L VIN U (2001)
11. Remove the outer part of the seal.
Installation Procedure
1. Install the J 43484 (2) to the J 8092 (1).
2. Install the transfer case front input shaft seal on the J 43484.
3. Using the J 43484 (2) and the J 8092 (1), install the transfer case output seal.
4. Install the front propeller shaft.
5. Check the transfer case fluid level.
6. Install the transfer case shield.
7. Lower the vehicle. Refer to Vehicle Lifting.
Transfer Case Output Shaft Seal Replacement - Rear
Transfer Case Output Shaft Seal Replacement - Rear
^
Tools Required
-
J 37668-A Seal Installer
Removal Procedure