K 2500 Suburban 4WD V8-8.1L VIN G (2002)
1. Position the EVAP canister purge valve (1) on the intake manifold.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the EVAP canister purge valve retaining bolt (2).
Tighten
Tighten the EVAP purge valve retaining bolt to 10 N.m (89 lb in).
3. To connect the purge pipe connector (1), press the components together in order to snap the tab (2) in place.
4. Connect the purge pipe to the EVAP canister purge valve.
5. Connect the EVAP canister purge valve harness connector (1).
