K 2500 Truck 4WD V6-262 4.3L (1988)
1.
Raise Vehicle - Locate the frame bracket (left front cab mounting bracket) where the park brake cable is routed through the rear flange of the
bracket. Clean the rearward face of the flange around the cable and adjacent frame area if necessary (Figure 1).
2.
Position the park brake cable stretch bracket against both the rear flange of the frame bracket at mount) and the frame so that the notch cut in the
stretch bracket partially encircles the park brake cable where it passes through the rear flange of the frame bracket.
3.
Secure the bracket with a pair of locking pliers. Center punch all four holes. Two on the rear flange on the frame bracket and two on the frame.
4.
Remove the locking pliers and the park brake cable stretch bracket. Drill four 3/16 in. (4.76 mm) pilot holes at the previously, center punched
locations.
5.
Then drill the pilot holes out to 23/64 in. (9.00 mm).
