K 2500 Truck 4WD V6-262 4.3L (1988)
FIGURE 1 - CRUISE CONTROL CABLE INSTALLATION 1988 C/K (TYPICAL)
^
Using hose clamp, part number 22537006 or equivalent*, install it over the conduit engine fitting. Make sure it is centered over the fitting so that
the clamp will hold it in the locked position, Figure No. 1 View A.. Tighten clamp to 2 N-m (20 in.lbs).
*
A stainless steel worm gear type clamp capable of achieving a diameter of 1.25"
with a band width of approximately .25" to .5".
PARTS INFORMATION
Parts are to be obtained from General Motors Service Parts Operation (GMSPO). To ensure that these parts will be obtained as soon as possible, they
should be ordered from GMSPO on a C.I.O. order with no special instruction code, but order on an advise code (2).
PART
NUMBER
DESCRIPTION
OUANTITY
22537006*
Hose Clamp
1
*
A stainless steel worm gear type clamp capable of achieving a diameter of 1.25" with a band width of approximately .25" to .5".
WARRANTY INFORMATION
Dealers should submit a warranty claim on each vehicle completed under this campaign.
LABOR
OPERATION
TIME
TROUBLE
NUMBER
DESCRIPTIONALLOWANCE CODE
V4150
Install clamp
.2hr.
96
*Add 0.1 hour for administrative time allowance.
CAMPAIGN IDENTIFICATION LABEL
Each vehicle corrected in accordance with the instructions outlined in this product campaign bulletin will require a "Campaign Identification Label".
Each label provides a space to include the five (5) digit dealer code of the dealer performing the campaign service. This information may be inserted
with a typewriter or ball point pen. Each "Campaign Identification Label" is to be located on the radiator core support in an area which will be visible
when the vehicle is brought in for periodic servicing by the owner. Apply "Campaign Identification Label" only on a clean dry surface.
ADMINISTRATIVE PROCEDURE
Procedures covering this campaign are outlined in Section V of your dealership's "GMC Truck Claims Processing Manual" #P 8719.
Dear GMC Truck Owner
