K 2500 Truck 4WD V6-262 4.3L (1988)
^
J 36600 Seal Installer (K1/2 models)
^
J 22833 Seal Installer (K3 models)
1. New seal (29). Use J 36600 (K1/2 models) or J 22833 (K3 models). Lubricate the seal lips with grease.
2. Deflector (31).
3. Output shaft (32). Carefully pry against the lower carrier to provide clearance. Take care not to damage the carrier case. Tap the output shaft into
place with a soft mallet.
4. Lower carrier mounting bolt, washers, and nut.
Tighten
^
Bolts to 110 N.m (80 lbs. ft.).
5. Left drive axle.
6. Tire and wheel.
^
Add lubricant as required to the axle.
Shaft and Axle Tube Assembly Replacement
Remove or Disconnect
^
Raise the vehicle and support it using safety stands.
^
Position a pan under the axle to catch oil.
1. Bolts (63) from the left and right stabilizer brackets (64).
2. Right stabilizer link nut assembly (50), spacer (56), and link bolt assembly (62).
3. Inner tie rod end from relay rod.
