K 2500 Truck 4WD V6-262 4.3L VIN Z (1992)
48-44084
48-44084
1GTEK14ZXNE500384
48-44095
48-44095
2GTEC19K2M1553220
48-47082
48-47082
2GTEC19K8M1553187
48-47088
48-47088
2GTEC19KXM1553191
48-47088
48-47088
2GTEC19K3M1553193
48-47246
48-47246
2GTEC19Z9M1553177
48-47249
48-47249
2GTEK19K5N1500015
48-47249
48-47249
2GTEC19KXM1553207
48-47281
48-47281
2GTEC19H7M1553170
48-47281
48-47281
2GTEC19K5M1553180
48-47321
48-47321
2GTEK19K4N1500216
48-47329
48-47329
2GTEC19K1M1553189
48-47329
48-47329
2GTEC19K1M1553208
48-47667
48-47667
1GTEK14K0NE500946
48-50035
48-50035
2GTEK19K1N1500030
48-50274
48-50274
2GTEK19K6N1500086
48-51020
48-51020
2GTEC19K3M1553176
48-53301
48-53301
1GTEK14K8NE500340
48-56790
48-56790
2GTEC19K0N1500243
Dealer, Owner, & Service Information
DEALER CAMPAIGN RESPONSIBILITY
Dealers are to service all vehicles subject to this campaign at no charge to owners, regardless of mileage, age of vehicle, or ownership, from this time
forward. Dealers are to correct all affected vehicles in new vehicle stock prior to their sale.
Should vehicles be sold inadvertently from your new vehicle inventory, prior to repair, owners are to be contacted by the dealer and arrangements made
to make the required correction according to instructions contained in this bulletin.
OWNER NOTIFICATION
There will be no owner letter sent out with this campaign. Due to the stop sale issued prior to vehicle sale, it is anticipated the vehicles should still be in
your new vehicle inventory and should be repaired prior to retail sale. If a unit has been retailed, in order to maintain customer satisfaction, contact the
owner immediately and arrange to correct this condition on his/her vehicle.
SERVICE INFORMATION
Suspect axle shafts can be positively identified by the Julian date stamped on the axle shaft flange between wheel pilot and bolt circle. The date code
stamped on the axle flange consists of four (4) digits. The first three (3) digits are the Julian date and the last, or fourth digit, is the manufacturing plant
shift code.
AXLE SHAFT FLANGE CODE EXAMPLE:
2192
(219 = Julian Date) (2 = Plant Shift Code)
INSPECTION PROCEDURE
1. Raise vehicle.
2. Remove both rear tire and wheel assemblies.
3. Carefully remove the brake drum retaining clips and brake drums.
4. Check Julian date stamped on axle shaft flange between wheel pilot and bolt circle.
Julian Dates other than 219, 220 or 221:
Reassemble vehicle, install "Campaign Identification
Label" and release vehicle for sale. No further action
required.
Julian Dates of 219, 220 or 221:
Proceed to Replacement Procedure.
Replacement, Parts, & Warranty Information
