K 2500 Truck 4WD V8-305 5.0L VIN M SFI (1996)
Distributor: Adjustments
Procedure A
Distributor Installation and Removal
Procedure A
Remove or Disconnect
^
Make sure the ignition switch is "OFF."
1. Spark plug and coil leads from the distributor cap.
2. Three wire hail effect switch plug from the base of the distributor.
3. Two screws holding the distributor cap to the housing.
4. Distributor cap.
A. Use a grease pencil to note the position of the rotor segment in relation to the distributor housing. Identify the mark with a 1.
B. The distributor housing and intake manifold should also be marked with a grease pencil for proper alignment when reinstalling.
5. Mounting clamp hold down bolt.
6. Distributor.
^
As the distributor is being removed from the engine, you will notice the rotor move in a counter-clockwise direction, 42°. This will appear as
slightly more than one clock position. Noting the position of the rotor segment, by placing a second mark on the base of the distributor, will aid
in achieving proper rotor alignment during distributor installation. Be sure to identify the second mark on the base with the number 2.
Install or Connect
Distributor Alignment Indicator
A. If the original distributor is to be replaced, rather than repaired, remove the new distributor cap. Using a grease pencil, place two marks on the
