K 2500 Truck 4WD V8-305 5.0L VIN M SFI (1996)
TIGHTEN
-
Bolts securing the switch to 28 Nm (21 lb. ft.).
4. Remove Tool J 41364 from the switch.
5. Wiring harness connectors to the switch.
6. Transmission control lever to the manual shaft.
7. Transmission control lever to the manual shaft with the nut.
TIGHTEN
-
Control lever nut to 28 Nm (21 lb. ft.).
8. Lower vehicle
9. Negative battery cable.
INSPECT
1. Check the switch for proper operation.
-
The engine must start in the "P" (Park) or "N" (Neutral) positions only. If adjustments is required, loosening the switch retaining bolts and
rotate the switch slightly, then tighten the bolts and check the switch for proper operation.
