K 2500 Truck 4WD V8-305 5.0L VIN M SFI (1996)
Constant Velocity Joint Boot: Service and Repair
Remove and Reinstall CV Joint and Seal
Remove Drive Axle Seal Cover (Optional)
-
Required Tools:
-
J 8059 Snap Ring Pliers
-
J 35910 Seal Clamp Tool
1. Use side cutters to cut the drive axle seal cover clamps and the nylon strap.
Important: If the drive axle seal cover will be reused, do not damage the drive axle seal cover while removing the clamps.
2. Slide the drive axle seal cover off of the drive axle, over the CV joint end.
3. Check the drive axle seal cover for rips, tears, worn spots or other damage. Reuse the drive axle seal cover if there is no damage visible.
Remove Deflector Ring From CV Joint Assembly
-
Required Tools:
-
J 8059 Snap Ring Pliers
-
J 35910 Seal Clamp Tool
