K 2500 Truck 4WD V8-379 6.2L DSL VIN J FI (1992)
attaching the liner as you go. Repeat this process to the opposite fender.
2.
Apply the rear fender liner to the inside rear of the fender as illustrated (Figure 1). Take care to overlap the rear liner on the top liner as illustrated.
Repeat this process to the opposite fender.
3.
Apply moderate pressure to the entire surface of the fender liners to insure good adhesion to the inside of the fenders.
Parts Information
Part quantity reflects the number required to do both fenders on one vehicle.
P/N
Description
Qty
15741040
Protector-rear
2
fender upper
15741041
Protector-rear
2
fender rear
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use:
Labor Op
Description
Labor Time
B8340
Install fender liner,
0.3 hr
right side
B8341
Install fender liner,
0.3 hr
left side
B8342
Install fender liner,
0.5 hr
both sides
Technical Service Bulletin # 231054R
Date: 930701
Paint - Identification/Repair of Colorcoat Delamination
BULLETIN NUMBER: 92-1O-134A
SECTION: 10 Body
NUMBER: 4
CORPORATE REFERENCE NUMBER: 231054R
DATE: July 1993
SUBJECT:
SERVICE PROCEDURES FOR IDENTIFICATION AND REPAIR OF PAINT COLORCOAT DELAMINATION FROM ELPO PRIMER
MODELS:
1988-92 TRUCKS
THIS BULLETIN CANCELS AND REPLACES TRUCK SERVICE BULLETIN 92-10-134 (CORP # 231054R), DATED OCTOBER 1992. IT IS
BEING REVISED TO REMOVE THE COVER LETTER PORTION AND SUBJECT STATEMENT NOW INCLUDES NOTE FOR TRUCKS AND
REVISES THE MONOCOAT MATERIAL ALLOWANCES ON "G", "S/T" AND SOME "R/V" MODELS. THE ALLOWANCE FOR "ADD FOR
TWO-TONE" ON G AND S/T TRUCKS HAS BEEN CHANGED. ALL COPIES OF 92-10-134 SHOULD BE DISCARDED.
The revisions are the result of changes to the MONOCOAT (ENAMEL) material allowance charts published in June, 1993.
Six (6) of the "G" model revisions use Basecoat/Clearcoat material allowance codes. THESE ARE TO BE USED AS DOLLAR REFERENCES ONLY,
AND ARE MARKED WITH A # INDICATOR. Continue to repair these vehicles with monocoat materials. DO NOT repair these vehicles with
Basecoat/Clearcoat products.
Use the latest (June, 1993) material allowance charts when submitting claims.