K 2500 Truck 4WD V8-379 6.2L DSL VIN J FI (1992)
Fig. 5 Control Valve Assembly
Removal
1.
Drain and remove oil pan and remove filter and gasket.
2.
Disconnect electrical connectors at valve body, Fig. 4.
3.
Remove bolts from valve body assembly, manual detent spring and roller assembly, Fig. 5. Ensure five O-rings are attached to pressure manifold
assembly.
4.
Remove pressure manifold assembly.
5.
Remove wiring clips, fluid level indicator stop, lube pipe, lube pipe retainer and clamps.
6.
Remove control valve assembly including accumulator housing assembly, valve body gaskets, spacer plate and accumulator gasket.
7.
Remove the eight check balls from case passages.
8.
Remove two speed sensors and bracket assemblies and PWM solenoid screen.
