K 2500 Truck 4WD V8-393 6.5L DSL VIN P (1995)
Important
-
Do not cut through the seal (10) with the chisel and damage the sealing surface of the tripot outer housing (1).
2. Small seal-retaining clamp (11) from the axle shaft (12) with a side cutter, and discard.
-
Separate seal (10) from the tripot housing (1) at the large diameter and slide the seal away from the joint along the axle shaft (13).
3. Tripot housing (1) from the spider (3) and shaft.
-
Spread the spacer ring (8) with J 8059 and slide the spacer ring and the tripot spider (3) back on the axle shaft (13).
4. Shaft retaining ring (2) from the groove on the axle shaft (13) and slide the spider assembly off the shaft.
Important
-
Handle the tripot spider assembly with care or the tripot balls and needle rollers may separate from the spider trunnions.
5. Remove the spacer ring (8) and the seal (10) from the axle shaft (13).
6. Flush grease from the housing.
Assemble
1. Small seal-retaining clamp (11) on the neck of the seal (10).
-
Do not crimp.
2. Slide the seal (10) onto the shaft (13) and position the neck of the seal in the seal groove on the axle shaft.
