K 2500 Truck 4WD V8-454 7.4L VIN J SFI (1997)
Install or connect the following:
1. New ball joint into the lower control arm.
-
Apply a 6 mm (1/4 inch) bead of Loctite 680 evenly to the serrations on the ball Joint prior to installation.
-
Position ball Joint in control arm with grease fitting toward rear of vehicle.
-
Press in the ball Joint using tools shown. The ball joint will bottom on the control arm.
-
When installing ball Joint with J 41435, ensure notch in tool is aligned with grease fitting.
2. Ball joint into the steering knuckle.
3. Stud nut onto the stud. Tighten to 128 Nm (94 ft. lbs.) and align the slot in the stud nut with the hole in the stud by tightening.
4. New cotter pin to the stud.
5. Drive axle (halfshaft).
6. Brake caliper.
7. Tire and wheel assembly.
-
Lower the vehicle.
NOTE: Check the front wheel alignment.
